Category: Plug & Play
El módulo LED Tri Cree utiliza tres LED XPE-2 montados en un MCPCB de cobre.
Los LED se ensamblan en casa, incluyen resistencias y están alojados dentro del módulo LED que se muestra en la imagen.
| Especificaciones | |
|---|---|
| Diámetro | 0.995 in |
| Altura | 0.755 in |
| Material | Cobre |
The copper MCPCB on this thing actually pulls heat away nicely, I ran it for twenty minutes straight and the housing stayed warm but never hot. Resistors pre-soldered saved me a lot of fiddling.
Swapped this into a flashlight build and the three XPE-2 emitters are noticeably brighter than the single LED I had before. Came pre-wired with resistors already on the board, so I had it running in about ten minutes.
The copper base makes a huge difference for heat—even during a long duel, the hilt stays comfortable to grip. I wired it in under an hour, and those three XPE-2s throw out a seriously bright, even beam. Very happy with how clean the solder points are on the board.
